Hello,
I dont have awful a lot of experience setting up VLANS and previously I was setting them on Netgears. So at the moment I am struggling with setting VLAN config on your Draytek 2960.
For security reasons I setup 18 lan interfaces linking up to VLAN id from 101-119 via
LAN General Setup 802.1Q VLAN
Next if I need to connect say PORT 4 to main switch and I want to send all the VLANS through this port to switch how I configure port ?
According to this article http://www.draytek.com/index.php?option=com_k2&view=item&id=5516&Itemid=293&lang=en
LANSwitch 802.1Q VLAN
I need to select VLAN id then specify port membership which means that VLAN will be going through it to correct LAN interface =however what does ' Untag' is affecting it ?
And should I untag all the VLANs that are going though the port ? At the moment I can untag only one per...